Month: April 2008

LG FL Washer – 2277 – OE error

We bought an LG 2277 washer sometime in the past year. A couple of times it has had the OE error, which means the drain needs unplugged, or the drain filter needs cleaned out.

We haven’t thought about it in any sort of regular fashion, to do something about it beforehand, but will be doing just that now.

Yesterday, early evening, the OE error started, and nothing would get the washer going. I didn’t do much with it, but my hubby did, and he gave up on it finally late last night.

When the OE error shows, you have to look at the filter, which is on the left front of the machine, at the bottom. To do this you have to open the little door to the area, and there on the far left is a little black tube, with a stopper in the end. This must be drained first, before moving on to opening the filter for inspection/cleaning (or else have a little flood on your hands/floor.) Unplug the washer first, to be on the safe side.

The little tube is low to the ground and you have to find some way to drain it. We have a window nearby, the tube in no way is long enough to go to a window or sink or such. The window, in our case, is useful since we have no sink in the laundry room. We use a wash basin or a pan to collect the water, and then throw the water out the window (into the front yard.) It takes two or three fill ups to drain enough out, generally.

Once that part is done, tube back in place, the filter can be unscrewed, it’s to the right of the tube. Some water may come out as you loosen this part, so a towel on the floor, tucked under the edge of the washer, is very useful. The filter is one large-ish plastic piece, and it should be cleaned out, just pull stuff out/off, and rinse off with water if you wish. Put the filter back, make sure it’s screwed back down all the way, make sure the tube and it’s stopper are in the right place, and then plug the electric back in, and set your load to wash and see if it works.

Now this is the general way of dealing with the OE error. It has worked for us before, but we went through it time and again, and again,and again, and again and futher than that last night. Today, late morning, hubby started at it again, and still had no success, though he had drained it and drained it, and tried and tried. I got involved here and there. We also took the big drain hose out of the house drain and snaked up it and also down the house drain. Nothing much came up or out.Just a few tiny pieces of stuff which didn’t do anything to change the situation.

I eventually stumbled onto something that I had overlooked in the manual, a way to just make the washer “spin” and nothing else. It’s not a setting on the machine, but works by turning on the machine, and then only touching the SPIN SPEED button. Choose any speed, and 14 minutes shows on the display window. Press start/pause to begin the spin cycle. Any water in the load should spin out and be drained out. I found it in the manual, but it wasn’t under any sort of “Spin Cycle” heading, and it made sense as to why I’d overlooked it previously.

What was going on with our machine though, was that nothing would work. Sometimes we could get a regular wash cycle to start, but it would quit in the middle of the cycle with the OE error again. Other wise we couldn’t get it to do anything. Draining it again and again.

I stumbled on the “spin” thing late mid-afternoon, but was having a problem with the machine still, it wouldn’t move, though it said it was doing what I wanted it to.

I finally started doing more draining, and after that I found that it did do the “Spin cycle” and it really worked. I didn’t let it quite finish though, anxious to do a regular load, and get the wash all going again (with plenty more loads waiting to be done.)

That dreaded OE error came again though. So I drained the machine and looked at the filter, and then I took a long piece of wire and poked as far as I could into the drain tube in the front, and then into the hole left when the filter is taken out.

So when I had the machine plugged in and turned it on, I tried the “Spin Cycle” again and it worked, and we let it run fully. It finished fine.

Then we ran a small load, on “quick cycle” and that worked fully. We watched the whole cycle, and seemed to think at one point when the washer was draining that it made a little “thunk” sound and then there was a decently loud draining/suction sound from there on out.

So for better or worse, it was the draining, and cleaning out filter and poking into holes that helped, but only after we let a SPIN cycle go fully through.

I found one website which had people talking about LG washer problems, and one person said that LG Customer Service had told them that the front drain tube should be drained out after every 4 to 5 cycles run. That sounds crazy! Is that for all LG Washers, or just ones that have a leaking problem (which ours did not, but we had a bad cycle of it wouldn’t work … until it was drained AND spinned out … and maybe my poking and prodding actually did something?)

Our experience has taught us that we will do this maintenance at the least monthly, and maybe weekly. Just to get it before it’s ugly head is reared.

It’s worth the higher maintenance (than our old top loader) to have the front loader. It’s not much, just some draining, and cleaning of filters, kind of weird, but not so bad once you do it and see how it works.

I’m glad that I now understand that our machined DOES have a “SPIN ONLY Cycle” — this troublesome last day of machine woes taught us the worthiness of the drain/filter maintenance, and the spinning ability, and I’m glad to have learned these things, and things often must be hard lessons to stick. KWIM?

Cooped up and Projects

Things are greening up massively outside, Spring is here. I feel so cooped up though, with little access to the back yard, only through the dark hole like downstairs, which I despise to go through. It was supposed to be our “family room” but has just become a place where I don’t go, it’s dirty and junkier than I can stand. The children go down there and watch TV and spend time there, and just make the couch all dirty and make a general mess. We have things boxed up there too, with no storage in the house to speak of, so it’s a cramped space at best, and there is little light, so it’s a dark hole to me. It’s a concrete floor as well, so I do not care to try to make it seem nice, it just wouldn’t be for me and the baby, no matter what, for now.

One of these days we’ll get a new deck built and the sliding doors in the kitchen, then I will have back yard access again. 🙂 And sometime later hopefully we’ll have a patio by the deck, which the downstairs “hole” will open up out onto, and a new door there as well, to let in more light.

We have indoor projects to get done too though, getting a new floor laid for the main level and completing the floors upstairs (which are partially put in) and then all those floors will need sanded and finished (a true tung oil finish.)

Then getting the kitchen cabinets “installed” and countertops ordered and installed, and more …

There is so much inside that needs done, and outside, including the house needs painted in and out. All these things are big deals, take $$$$ and hard work together, which are not anything I can affect myself, so I feel cooped up. Living with the not yet.

Speaking of that, we are super watchful of the baby since he can crawl and cruise, he’ll be walking anytime now. We have to retrofit the stair areas so that we can install gates. It’s been so long since we had babies to baby proof for, and “back in the day” it was a nightmare getting the stairs “gated” and it just won’t work out this time to try without re-building parts of things.

Baby has to spend more time in his play yard now, which he just ain’t happy about. That’s the price he has to pay though, so he doesn’t tumble down any stairs. It really feels more like MY price to pay, since I have to listen to the wails of “let me out” for 70% of his play yard stays. He’s content to play on the safe floor for awhile, then remembers the stairs to up … and off he powercrawls and starts to climb, and after him I have to go to get him off the stairs. Then it’s play yard time, or sometimes baby swing time, or crib time.

Play yard time is wailing time, but crib time is wailing an screaming time, and oh boy that just never changes. He wants to be with me, free to hold onto me if he wants, not separated at all. He’s so active though, as well, and that makes holding him impossible, even when he seems to want to be held, so it all goes in cycles, hold, put down, play nice, then crawl to stairs, into my arms, too squirmy, into play yard, or swing or crib, cry, cry, cry, or add in screaming, stay there awhile, come out and start it all over again. Getting the stair areas gate-able will really help me out. So that, I think is the one thing we must tackle. It really should cost $ or at the most $$. It’s necessary, but we can’t do it until we have the money to do that, and we are going out of town when we next get paid, and so it’ll be us living with this for another week, then leaving for a few days, then coming back to this and hopefully having the money and energy to tackle the project.

Just that alone will be a reassuring thing, safety is important.

© 2019 Pastoral Farms

Theme by Anders NorenUp ↑