Day: January 31, 2016

Our Electrolux Stove is out of commission

Our EW30EF65GSA suddenly had a major problem over a week ago now. The front right burner, radiant element under a glass top, dual-burner, turned ON but was too hot, like on super HIGH. Turned it off, it was flashing HE as usual and looking settings-wize was OFF, but still burning hot on HIGH and looking full ON.

Since that Thursday mealtime flub-up, we haven’t been able to use the stove at all. I’ve ordered and installed a new burner, that wasn’t it. The burner has Continuity still, but there is no way to test the center piece that is called a “limiter” so changing out the burner was step one of correcting the problem.

I’ve read so many sites, looked up parts, memorized my stove model number without even trying to.

I replaced a board in the back but it wasn’t the one to affect change, but I was happy to have that replaced anyhow, not that it was needed now,  but it would be in the case of it shorting out, etc. New functioning part good, for the most.

So the problem ends up probably being the relay board or the wires … which one I don’t know and will not tackle further. Wire Harness is what needs replaced if it’s a wire and wow, not a fun or easy thing. Not impossible, but I am just sick of this machine.

We will be contacting a technician to come out and … who knows what. I wanted to fix it up more than that, also somehow find a new glass top for it, and some time replace the bottom of the  main oven (I can still do that sometime easily.)

I have another project I’m working on, our Fridgidaire Freezer, model FKFH21F7HW* — I started working on it before the stove starting erroring. When it rains, it pours.

Fridgidaire Upright Freezer E8 and more

Our freezer has had problems for a long while now. I finally had enough of it, decided to look deeper into it. Hurray! It’s definite that two things I’ve gotten for it were better for it. Front control panel and the Temperature Defrost gizmo are what I’ve replaced  (I tested the Temp Defrost when it arrived, and it checked out properly.) Next is the door gasket, I have it, hope to get it installed today.

Tomorrow the new Thermistor will arrive in the mail. It’s the key, I do hope, to why the freezer wasn’t working as well in the beginning and ended up where it was when I picked up this project … totally frosted over and iced up bottom of the freezer … the drain plug was one big ice puck. Nothing would defrost. It was cold, but saying the door was open and alarming all the time.

I put the new front control in, and vwomp, it stays closed better, but still needs a new gasket. Since putting in the control panel it’ll run cold, but eventually E8 error.

I took the Temperature Defrost off, testing it and it was dead. Got a new one, meanwhile defrosted the freezer manually, took everything out put it into a big 7-day cooler, it took a day and night and partial day, but eventually the ice melted and all the water drained, what a mess.

That E8 error and HIGH TEMP are what are the two normal views on the display now. The Thermistor, if it’s not the key, it’s the key stone. Last probable need to change will be that heater piece. I don’t know if it is needed. Once the Thermistor and Gasket are both installed I’ll plug it back in and see what happens. Holding out hope. 🙂

© 2021 Pastoral Farms

Theme by Anders NorenUp ↑